Approx 660 ft max per roll, some have less and will be sold at reduced price. 24 Reels on site in Whitehorse, more in Alberta.
Located in Whitehorse, Yukon - Sales Yard
A high-pressure, high strength lay-flat hose designed for pumping aggressive water around mine sites.
Mineflex is manufactured with high tenacity fibers completely protected with an abrasion-resistant, polyurethane material. Mineflex has been designed to assist with mine dewatering where the constant movement of pumps and surface equipment makes rigid and semi-rigid piping a problem. Being totally lay-flat, this product is lightweight and easy to handle.
Extra abrasion resistant for rugged terrain and extreme conditions
Resistant to oil and chemicals
Integrated inner and outer coating of abrasion resistant Polyurethane
Heavy duty, high pressure applications
pH 3 – pH10 at ambient water temperature
Flexible in all weather conditions from -40 deg C to 70 deg C.(-40 deg F to 160 deg F)
Available in max lengths of 200m (660ft)
Some hoses have Oroflex 200 marked on them, here is the description:
Hose shall be made from 100% high tenacity synthetic yarn circular woven and completely, protected by extruded through the weave synthetic rubber, forming a single homogenous construction without the use of glues or adhesives of any type.
a. Ultimate Tensile Strength:
Tensile strength of the lining and cover shall not be less than 1750 psi (12,000 k Pa ).
b. Ultimate Elongation:
450 % minimum.
In very extreme conditions where abrasion is the most serious concern OROFLEX 20 would extend hose life. Hose should have excellent abrasion resistance when tested with TABER abraser Wheel H-18 and 1000gr load.
Hose shall show no visible signs of cracking of the lining or cover when tested in accordance with ASTM D1149- 64 (R1970), ASTM D518 Procedure B, 100pphm/118 F/70 hours.
Exposure to seawater and contamination by most chemical substances, hydrocarbons, oils, alkalis, acids and greases must have no effect on the short or long term performance of the hose. A chemical resistance chart is available and TIPSA will supply specific chemical resistance data on request of purchaser for unique applications
The hose when subjected to a static pressure of 100 psi ( 700 k Pa ) shall be capable of withstanding a surface temperature of 1112 F ( 600°C) (for a minimum of two minutes without rupture or damage to the synthetic reinforcement.
Cover damage, small holes and punctures are repairable with use of REPOKIT and Vulcanizer. Full instructions for use supplied on request.
Standard 50’ (15m), 100’ (30m), 200’ (60m). special lengths up to 660’ (200m)
|Part #||Nominal D||WP*||Burst||End Pull||Weight||Thickness||Request a Quote|
* Working Pressure can be raised up to 150 psi (10 bar) if a safety ratio of 2.5 over burst pressure can be accepted.